Sper-scientific 850037 Large Display Conductivity Pen Manual de usuario descargar pdf (Pagina 28)

Resetting the Pen (rSt)

When the pen is reset, all parameters

(including calibration information) will be

reset to factory default values.

1. Press SET for 2 seconds to enter setup.

2. Press ▲ to select the reset pen setting.

“rst” will appear on the main display of

the LCD and “P3.0” will appear on the

secondary display.

3. Press SET again for less than one

second to enter the reset setting.

4. Press ▲ to select Y (yes) or N (no).

5. Press SET for less than one second to

conrm the selection or press SET for

more than 2 seconds to return to P3.0

without saving.

P2.0: TDS factor setting: (tdS,8361 only)

P2.1: Setting TDS factor(tds):

In P2.0, press " " momentarily to

enter P2.1. (P2.1 will not display on

LCD). The factor will flash on LCD.

Press " " or " " to change factor

from 0.40 to 1.00. Press " " momen-

tarily to confirm the value and meter

will return to P2.0. Or pressing " "

more than 2 seconds to return to

P2. 0 without confirming the value.

P3.0: Reset meter: (rSt)

In P2.0, press " " or " " to enter P3.0.

When you decide to reset the meter, all

parameters will be reset to factor default

values include the calibration info.

NOTE:

Pay attention

to the dif

fe-

rence between

short or long

press " "

after setting

the tds value.

In P1.0, press " " to select P2.0.

P3.1: Reset

In P3.0, press " " momentarily to

enter P3.1. Press " " or " "to select

Y or N. Press " " momentarily to

confirm the state and return to P3.0.

Or press " " more than 2 seconds

to return to P3. 0 without confirming

the P3.1 value.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Comentarios a estos manuales

Sin comentarios

Sper-scientific 850037 Large Display Conductivity Pen Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Sper-scientific 850037 Large Display Conductivity Pen